User's Manual

3.2 Mounting Instructions 5 Controlling the System

4. Press the rotary knob for approximately two seconds to select the loaded

configuration

Note

If you press the rotary knob short the transmitter discards your selection.

Note

If you change the scrambling mode of a preset this is only stored temporarily.

For permanent activation resp. deactivation of scrambling use a computer and

the configuration software.

 Power amplifier level

1. Press the rotary knob labelled “TUNE” for approximately two seconds

2. Turn the knob until “RF LEVEL” is shown

3. Press the knob for approximately two seconds to set the level of the power

amplifier to low or high

4. Press the rotary knob for approximately two seconds to select the loaded

configuration

Note

If you press the rotary knob short the transmitter discards your selection.

Note

By default RF power is set to high.

SYSTEM POWER SWITCH

 Power on the system

Shift the switch to position “ON”. The display lights up orange during

initialisation phase. After approximately 10 seconds the display lights green.

Note

When switching on the system a valid video (and optionally audio) signal must

be present on the selected input.

 Power off the system

Shift the switch to position “OFF”. The display switches off. Now the

CT6540ARINC transmitter is powered off.