User's Manual

Chapter 3: Options and Upgrades
Reference Guide: CT2200HDV Page 6
May 07
Connecting Signal Sources
The encoded Video/Audiosignal supplied by the camera have to applied to the IEEE
1394a connector of the transmitter.
Connecting the RF Output
A Omni directional antenna with SMA(m) connector can be directly mount at the RF
out socket.
Connecting the 12VDC Supply Voltage
Caution
When using a battery or power pack, make sure that the maximum
supply current is at least 3A and the output voltage matches the
input voltage range of the CT2200HDV.
Failure to comply with these requirements may cause fatal
damage to the battery/power pack and/or CT2200HDV.
Battery Powered Operation of the CT2200HDV
Many types of batteries are available on the market and we tried to support the best
ones.
On this way it is possible to order the Transmitter with Anton Bauer or Sony V-Mount.
Others on request.
Shut-Down
Caution
To shut-down the unit, first disconnect it from the 12VDC supply
voltage.
After disconnection from the supply voltage by removing the battery or disconnecting
the 12VDC supply cable, the other connecting cables can be removed from the unit.