Operating Instructions


04
Charging is finished* when both
the vehicle link indicator and the
LED ring light up green. You can
then disconnect your vehicle
from the eBox.
* Optionally, charging may also be
stopped via the RFID card you
used before or the eCharge+ app.
02
Authenticate the charging process
via RFID card or the eCharge+ app.
For the latter you will need the
charging port number displayed
on the front of the eBox.
The eBox can also be activated
from the backend.
Charging involves connecting your vehicle to the eBox, authenticating the charging process, charging your vehicle, and finally disconnecting
your vehicle from the eBox. Please make sure that the connected cable is hung carefully back up. (Steps 01 and 02 are interchangeable.)
01
Connect your electric vehicle to
the eBox. When your vehicle is
detected, the vehicle link indicator
and the ring light
up green.
Using charging cables properly
Do not use charging cables with
adapters of any kind on the eBox.
The use of extension cords is not
permitted.
03
Shortly after successful
authentication, the LED ring
and vehicle link indicator start
pulsing blue, and your vehicle
starts to charge. For energy
saving purposes, the ring goes
out after some minutes when
you move away from the eBox.
Charging
Charging
Launching the app

Launching the app
To activate bluetooth please press bluetooth pairing button
(see chapter Product overview).
Launching the app for a private installation:
1. Your electrician sets the installed charging
capacity in the eConfiguration app (freely
available in app stores, see QR codes at the
end of the page) by entering the number of
connected phases and amperages
2. Start the eBox from the eCharge+ app
(freely available in app stores, see QR codes
at the end of the page), after which you can
create an account, etc.
Launching the app for a (semi-)public
installation:
The eBox is commissioned by your electrician
with the aid of the eConfiguration app.
The PUK must be entered before the eBox
can be commissioned via the eCharge+ or
eConfiguration app.
The PUK can be found on the back of this
manual. Keep this PUK in a safe place, and
hand it over to the next owner of the eBox.
The PUK will be needed again for every further
commissioning and for every change to the
configuration via the eConfiguration app.
DANGER
Radiofrequency
radiation exposure
Information:
This equipment
complies with FCC
and IC radiation
exposure limits
set forth for an
uncontrolled
environment. This
equipment should
be installed and
operated with
minimum distance
of 7 3/4‘‘ (20 cm)
between the radiator
and your body.
WARNING
In the apps, select
the correct electrical
network type and the
current rating noted
on the eClick by the
installer. Otherwise,
functional limitations
may occur.
eCharge+ app eConfiguration app