Operating Instructions

Legal noticeNotes

Legal noticeNotes
The product eBox smart must always be
used in conjunction with the eClick.
Electric vehicle charger characteristics
(IEC 61851-1 Ed 3):
1. The product must be connected to an
AC mains.
2. The product is connected permanently
to the mains.
3. The product is eClick-compatible. It is avai-
lable with a Type-1 plug with connected cable.
4. The product is compatible with electric
vehicles charged with AC in Mode 3.
5. The product can be installed and used in
protected indoor areas and unprotected
outdoor areas exposed to rain and direct
sunlight.
6. The product can be used in closed and
public areas.
7. The product can be installed on walls and
in compatible Pole products.
8. The product eBox smart in conjunction
with the eClick or coverage is rated
electrical protection class I.
The open eClick is rated electrical
protection class I.
Disposal
The eClick and the eBox are are electrical
devices. These must be disposed according
to national and local laws and regulations.
Cleaning
The eBox may only be cleaned with water;
the use of lukewarm water is recommended.
Do not use cleaning agents containing solvents.
Dismounting
Before dismounting the eBox, you must first
disconnect it from the voltage supply. First
loosen the two grub screws on the side and
then take the eBox out of the eClick by pulling
down the locking bracket, taking out the
charging unit, and, if fitted, detaching the
Ethernet cable connecting the eBox and the
eClick. The eClick must be dismounted by a
qualified electrician.
Copyright © 2019 Broadband TelCom Power, Inc.
All rights reserved.
This document is copyright-protected. It may
not be changed, reproduced, or distributed
without the prior agreement issued in writing
by Broadband TelCom Power, Inc.
Broadband TelCom Power, Inc.
1719 S. Grand Ave.
Santa Ana, CA 92705, USA
DANGER
The eClick must be
disconnected from
the power supply
before disassembly.
Make sure that all
components are dry
during disassembly.
CAUTION
When disassembling
the eBox, make
sure that the eBox
is carefully removed
from the eClick so
that the flat ribbon
data cables, the
eClick and the eBox
are not damaged
during disassembly.