Installation Sheet

101653 Rev. A

Trim Installation

Trim Sleeve Installation

Slide trim sleeve (1) over the bonnet (2) and

O-ring. Ensure sleeve is properly positioned

over the front of cartridge with set screw access

hole downward. O-ring will help keep trim sleeve

securely in position.

Escutcheon Installation

Secure backplate (3) to rough-in body (4) using 4

screws (5) provided. Ensure backplate is oriented

front side forward.

Note: Be sure backplate is oriented front side

forward and markings are visible.

If mounting to an uneven surface, apply appropriate

sealant around the backplate to supplement rubber

seal. Align holes in escutcheon (6) onto backplate.

Secure escutcheon by threading trim nut (7) onto

diverter sleeve. Do not over-tighten. Ensure that

O-ring (18) is assembled to trim nut (7). Slide

diverter trim sleeve (8) over trim nut.

For thick wall installation, an optional extension

kit is available to accommodate up to 1" of

additional wall thickness. Order RP100670.

A. B.

Valve Handle Installation

Slide handle (9) over cartridge, aligning flat

surfaces inside handle with flat surfaces on

side of cartridge (14). Handle lever should point

downward (6 o'clock) in the off position. Secure

handle with screw (10). Ensure that O-ring (11) is

assembled on handle cap (13). Install handle cap

(13) by pressing it into place on top of the handle

(9). Secure cap by tightening screw (12) from the

underside of the handle.

Diverter Handle Installation

Slide diverter handle (14) onto trim sleeve (15).

Using an allen wrench, insert set screw (16) into

handle (14). Applying pressure, insert set screw

cover (17) until properly seated.

75P Series Installation