Installation Guide

ManualsBrandsBrizo ManualsTub & Shower FaucetsBrizo Deck Mounted Roman Tub Filler Double Handle with Hand Shower Less Handles from the Baliza Collection

10/13/09 Rev. A

Para instalación fácil de su llave

Brizo

usted necesitará:

•LEER TODAS las instrucciones completamente

antes de empezar.

•LEER TODOS los avisos, cuidados, e

información de mantenimiento.

•Paracompletarelbordeylainstalacióndevál-

vulas dentro de las paredes previa a la

instalacióndelallaveysusaccesorios.

For easy installation of your Brizo

faucet you will need:

•ToREAD ALLtheinstructionscompletely

beforebeginning.

•ToREAD ALLwarnings,care,and

maintenance information.

•Tocompletethedeckandvalverough-inpriorto

installingthistrimkit.

Pour installer votre robinet Brizo

facilement, vous devez:

•LIRE TOUTESlesinstructionsavantdedébuter;

•LIRE TOUS les avertissements ainsi que toutes

lesinstructionsdenettoyageetd’entretien;

•Installezlecorpsdurobinetetterminezle

pourtourdubainavantdeposerlesaccessories

de finition.

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

You may need/Usted puede necesitar/Articles dont vous pouvez avoir besoin:

SILICONE

Icons

1/8" (3.17mm)

3/32" (2.38mm)

1/8" (3.17mm)

3/32" (2.38mm)

SILICONE

62975 62975 62975 62975 62975 62975

ASMEA112.18.1/CSAB125.1

ICC/ANSIA117.1

Models/Modelos/Modéles

T67305&T67405

Baliza

Series/Series/Seria

TWO HANDLE ROMAN TUB TRIM

LLAVE Y SUS ACCESORIOS PARA BAÑERA

ROMANA DE DOS MANIJAS (MANERALES)

ACCESSOIRES DE FINITION DE ROBINET

À DEUX POIGNÉES POUR BAIN ROMAIN

“TheCommonwealthofMassachusettsrequiresallhand-heldshowerspraystocomplywiththeMassa-

chusettsStatePlumbingCode248CMRwherebytheirinstallationshallincludeadevicethatlimitsthe

maximumdeliverabletemperatureofhotwaterto110°Fandanapprovedbackowpreventionsystem.”

“LaCommonwealthdeMassachusettsrequieretodoslosaerosolesdemanodeladuchaconformarse

conelcódigo248CMRdelaplomeríadelestadodeMassachusettsporelquesuinstalaciónincluya

undispositivoquelimitelatemperaturaentregablemáximadelaaguacalientea110°Fyaunsistema

aprobadodelaprevencióndelaexpulsión.”

«LeCommonwealthduMassachusettsexigedetouslespulvérisateurstenusdanslamaindedouche

d’êtreconformesaucode248CMRdetuyauteried’étatduMassachusettsparlequelleurinstallation

inclueundispositifquilimitelatempératurelivrablemaximumdel’eauchaudeà110°Fetàunsystème

approuvéd’empêchementderefoulement.»

T67305

T67405

Summary of content (8 pages)

PAGE 1
62975 UP ® ACCESSOIRES DE FINITION DE ROBINET À DEUX POIGNÉES POUR BAIN ROMAIN C ® 62975 Models/Modelos/Modéles T67305 & T67405 62975 T67305 62975 Write purchased model number here. Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici. T67405 62975 62975 Baliza® Series/Series/Seria You may need/Usted puede necesitar/Articles dont vous pouvez avoir besoin: E 62975 62975 62975 ASME A112.18.1 / CSA B125.1 ICC/ANSI A117.
PAGE 2
Backflow Protection System Cleaning and Care Your Brizo® hand shower incorporates a backflow protection system that has been tested to be in compliance with ASME A112.18.3 and ASME A112.18.1 / CSA B125.1. It incorporates two certified check valves in series, which operate independently and are integral, non-serviceable parts of the wand assembly. Care should be given to the cleaning of this product.
PAGE 3
Model / Modelo / Modèle T67405 Model / Modelo / Modèle T67305 RP62977▲ Lift Rod Assembly Ensamble de la barrita de alzar Tirette RP51287 Stream Straightener, Gasket & Wrench Enderezador del Chorro, Empaque y Llave Concentrateur de Jet, Joint et Clé RP51287 Stream Straightener, Gasket & Wrench Enderezador del Chorro, Empaque y Llave Concentrateur de Jet, Joint et Clé RP62978▲ Spout Base & Gasket Base del Tubo de Salida con Empaque Embase du Bec avec Joint RP62976▲ Handle Base w/Gasket Base de la Manija
PAGE 4
A. B. T67405 2.5 mm (3/32") 1 3 4 2 3 4 2 1 RP40668 Diverter Assembly Ensamble del Desviador Dérivation 4 2 1 2 Maintenance B. Model T67405 A. If faucet leaks from spout outlet: Shut off water supplies – If faucet does not divert water from the spout to the hand shower, check that the lift rod (1) is securely threaded into the diverter (2). If the problem persists remove the lift rod and spout. Replace the diverter assembly RP40668. Replace Seats and Springs (1).
PAGE 5
1 T67305 2 T67305 8 5 1 7 1 4 6 2 3 T67405 T67405 8 1 1 5 2 3/32" (2.38 mm) 3/32 po 7 4 6 3 NOTE: The deck and valve rough-in must be finished before installing the trim kit. 2 Screw bases (1) with gaskets (2) over end valves (3). OPTION: Use silicone under the gasket if deck is uneven. Install gasket (4) with spout and base (5) onto the spout adapter (6). Be sure spout is resting firmly on the deck. Install set screw (7) and tighten to secure the spout (5).
PAGE 6
3 A. C. T67405 T67405 1 1 2 4 3 B. T67405 D. T67405 1 1 2 For Model T67405 Only C. Slide hose (1) through conical nut (2). Attach hose (1) to braided A. Install lift rod (1). Screw the lift rod until it drops down and metal hose (3) using gasket (4) and tighten. DO NOT install hand piece yet. rotates freely. B. Remove and discard the test cap and gasket (1). NOTE: This is an extra gasket, one is supplied with the hose. D. Install base (1) to nest (2) and tighten.
PAGE 7
4 1 7 T67305 5 6 1 3 1 2 4 3 5 2 T67405 10 9 3 4 3 3 1 2 2 4 4 8 Model T67305 Remove stream straightener and gasket (1) using supplied wrench (2). Turn faucet handles (3) all the way on. Turn on hot and cold water supplies and flush water lines for one minute. Important: This flushes away any debris that could cause damage to internal parts. Reinstall stream straightener and gasket. Install handles onto end valves.
PAGE 8
6 A. B. T67405 T67405 2 1 1 3 2 For Model T67405 Only A. Pull hose (1) to its farthest extension and point it down into the B. Attach hand piece (1) to hose (2) with gasket (3) between tub. Pull the lift rod (2) up to the full on position and flush water lines for one minute. After flushing turn off water at the bath valve handles. Return the lift rod to the down position. connection. Refer to maintenance section (page 4) for correct diverter and lift rod function.