Installation Sheet

106853 Rev. A

T60P Series Installation

Valve Trim Installation

(See following pages for Siderna® valve trim installation.)

Slide O-ring (1) over cartridge and the bonnet nut

(2). The O-ring, which acts as a spacer to steady

the sleeve, should rest behind the bonnet nut.

Note: Depending on the location of the valve in

the wall and wall thickness, an optional extension

kit (RP81665) can provide an additional 1 3/4” of

wall thickness.

If your model requires a spacer (1), insert it into

the sleeve (2) and push it to the front. Slide the

sleeve over the cartridge, body and O-ring.

Cylinder trim sleeve (4) does not require a

spacer. Ensure the word FRONT points out

and slide trim sleeve all the way on over the

cartridge.

Secure the escutcheon (1) to the

bracket (2) using the 2 screws

provided (3). Do not overtighten

escutcheon screws.

Slide trim ring (1) over trim sleeve (2) and insert into escutcheon

(3). Models with side set screw in handle base - Secure handle

onto the stem using set screw and hex wrench (7). Insert button (if

provided) into handle. Models with axial screw in handle blade -

Secure handle (4) onto the stem using screw (5) and a phillips head

screwdriver. Insert button (6)into handle.

Models with stem extender for handle

Install stem extender (8) onto valve stem and secure with screw (9).

Slide handle onto stem extender and tighten set screw (10). Insert

button (11) until properly seated.