Instruction Manual

109508 Rev. B
6
2
Siderna
®
Valve Trim Installation (T60080, T60280 & T60480)
Place the center hole of the escutcheon (12)
over the trim sleeve and carefully push it back to
the mounting plates (10). Magnets on the back
of the escutcheon will keep it in place.
E.
10
12
Place volume control handle (13) over valve
stem (14) and onto the trim sleeve (5). Lever
should point horizontally to 3 o’clock position.
Secure handle with set screw (15).
F.
13
14
15
5
Assemble the two mounting sleeves (9) and two
mounting plates (10). Slide the mounting plate
assemblies over the trim sleeve so that the tabs/
plates (10) are at the top and bottom of the trim
sleeve, as shown. Thread screws (11) into mounting
plates just enough to assemble the two sides
together. Slide the mounting plates back against the
wall and nish tightening the screws (11).
Using the mounting plates (10) as a guide, enlarge
hole around rough so that plates can be pushed up
to 1/8" into the wall. Tighten screws (11).
C.
9
9
11
10
10
11
D.
1/8"
(3 mm)
10
11
10
11