Instruction Manual

109508 Rev. B

D. Slide trim ring (1) over the cartridge and

sleeve and into the escutcheon. Install volume

control handle base (2) with lever to the right as

shown (3). Install set screw (4) or (5) followed by

the handle lever (6) or (7).

E. On most models, lever should point

downward to 6 o’clock position. Install set screw

(8) into handle (9). Push handle onto valve

cartridge and tighten set screw to secure handle.

Note: Some models include set screw covers

for volume control handle that should also be

installed.

Siderna

Valve Trim Installation (T60080, T60280 & T60480)

Using supplied Allen wrench, install both anti-

rotational pins (3) into holes (4) in the valve body.

USE CARE TO NOT DROP PINS BEHIND THE

WALL. It is important that the rough be mounted

in the wall as level as possible because of the

square shape of this product. Slide trim sleeve

(5) over the cartridge and bonnet aligning the two

legs (6) of the sleeve over the anti-rotational pins

(3). If the trim is not square, you can try removing

a pin and holding the sleeve secure with the two

set screws (7) provided. Make sure the sleeve is

pushed all the way back so the legs of the sleeve

rest against the valve body. The set screws (7)

should be in a position where they hit just behind

the bonnet nut (8). Tighten set screws (7).

Remove plaster guard (1) from rough (2).

Note: Depending on the location of the valve

within the wall and wall thickness, an optional

extension kit (RP82245) can provide an

additional 1 3/4” of wall thickness.