Instruction Manual

109508 Rev. B

If your model requires a spacer (1), install it into

sleeve (2). Slide the sleeve over the cartridge, body

and O-ring. Ensure sleeve is properly positioned

over the front of cartridge.

Valve Trim Installation

(See page 5 & 6 for Siderna

valve trim installation.)

Slide O-ring (1) over cartridge and the bonnet

nut (2). The O-ring, which acts as a spacer to

steady the sleeve, should rest behind the

bonnet nut.

Note: Depending on the location of the valve

within the wall and wall thickness, an optional

extension kit (RP74785) can provide an ad-

ditional 1 3/4” of wall thickness.

Secure the escutcheon (1) to the bracket (2) with

the 2 screws provided (3). Do not overtighten

escutcheon screws.

C1.

Install bracket (5) over the cartridge body using the 2

screws (6) provided. Install escutcheon (7) by placing

it over the bracket as shown and rotating it to lock the

tabs (8). Secure the escutcheon to the bracket using

set screw (9).

C2.