Instruction Manual

109508 Rev. B

Cartridge Installation

Rotate the cartridge (1) so the H (2) is on the hot

inlet side of the valve.

Insert cartridge into valve

body as shown. Make sure the cartridge tubes

and O-rings (3) are properly seated in holes at

the base of the body. Ensure the keys on the

body are fully engaged with the slots in the

body (4).

For back to back or reverse installations

(hot on right and cold on left): Rotate cartridge

(1) so the word “UP” (2) appears on the bottom.

Install the cartridge making sure that the keys are

fully engaged with the slots in the brass body (see

step B). Slide bonnet nut (3) over the cartridge and

thread onto the body. Hand tighten securely.

Back to back Installation

Normal Installation

(changes not required)

Reverse

Installation

Cold

Hot

Slide bonnet nut (1) over the cartridge and

thread onto the body. Hand tighten securely.

Turn o󰀨 water supplies. Remove bonnet nut

(1) and test cap (2) from the body. If this is not

a thin wall mounting, the entire plasterguard (3)

may be removed. If screen (4) is in place, remove

before installing cartridge.