User guide
9
If you experience any problems, please call the Helpline on
Getting started
Providing you have subscribed to your network’s
Caller Display service, the date and time is set
automatically for all handsets when you receive
your rst call.
The date and time is recorded with each
answering machine message you receive.
If you do not have a Caller Display service you can
set the date and time manually.
You can set the time format to the 12 or 24 hour
clock but when changing the clock you must
enter using the 24 hour mode i.e. for 2.30pm
enter 14:30. You can also change the date
format to present the day or the month rst,
see page 27.
When setting the time and date on one handset,
any other handsets registered to the base are also
updated automatically.
If the time or date format is adjusted then only
the handset being used will be updated, all
others will need to be changed independently
if required.
3. Charge the handset for at least 24 hours. When the handset is fully charged
the
icon will be displayed.
Any additional handsets supplied as part of a multipack are pre-registered to
the base so, once charged, are ready for use. The handset number is shown in
the display.
1. Press Menu, scroll
to CloCk & AlArM and press SeleCt.
2. Set DAte/tiMe is highlighted. Press SeleCt. The current date and time
setting is displayed.
3. Use the keypad to enter the correct time (using the 24 hour mode) and date.
Press ok to conrm.
4. Press BACk until you return to standby.