User manual

ENGLISH USER MANUAL
BRITEQ
®
10/12 TORNADO 7
11
28
Pan 16 bit
000-255
Pan in 16 bit precision
12
29
Pan Rotation
000-127
Pan Stop
128-191
Pan Speeds in CCW from slow to fast
192-255
Pan Speeds in CW from slow to fast
13
30
Tilt
000-255
Tilt(0~270°)
14
31
Tilt 16 bit
000-255
Tilt in 16 bit precision
15
32
Tilt Rotation
000-127
Tilt Stop
128-191
Tilt Speeds in CCW from slow to fast
192-255
Tilt Speeds in CW from slow to fast
16
33
Pan/Tilt Speed
000-255
Pan & Tilt Speeds from fast to slow
17
34
Control
function
000-007
DMX mode
008-037
Sound mode 1
038-067
Sound mode 2
068-097
Sound mode 3
098-127
Sound mode 4
128-157
Sound mode 5
158-187
Sound mode 6
188-217
Sound mode 0
218-247
No function
248-255
Reset
Remarks: While in DMX mode, the units can also run in sound activated mode by setting the control channel
(17 or 34) to the desired value. See the DMX-chart for more information.
(*) 16bit dimmer is not implemented yet in the V1.0.4 software, will be added in a future software version.
 MASTER/SLAVE WITH BUILT-IN PROGRAMS:
Select this function when you want an instant show. By linking the units in master/slave connection, the
first unit will control the other units to give a pre-programmed or sound activated, synchronized light show.
Typical connection of the master/slave setup:
It’s very important that the units have the following settings:
 MASTER this is the 1
st
unit in the DMX-line. It’s important that this unit has the following settings:
 Config Settings: set to Master (“M” in the upper right corner of the display)
 Operation Mode: you can choose one of the following options:
 Sound operation: you can select one of the 6 programs or “0” for all internal programs.
 Preset memory: the unit shows the factory program (not editable!)
 User memory: the unit shows the program that was made/edited by the user.
 SLAVE(s) these are all units connected behind the master. It’s important that these units have the
following settings:
 Config Settings: set to Slave (“S” in the upper right corner of the display)
 Operation Mode: set to “DMX Operation” = Yes (“D” in the upper right corner of the display)