User manual

ENGLISH USER MANUAL
BRITEQ
®
11/13 LDP-ACCUSPOT 7TC
C. Connect the optional JBS CA-8 controller for more control:
The JBS CA-8 controller can only be used in standalone or master/slave mode. Connect the controller to
the JBS CA-8 input of the first unit (master). Now you can control all the connected units:
BUTTON
ACTIONS
STANDBY
To blackout all the fixtures
FUNCTION
1.Synchronous strobe
in white color
2.The same color
chase
3.Different color
strobe
Select one of the
different colors.
Select one of the 12
different multi-channel
shows.
Select one of the
different color fade
modes.
MODE
Strobe
(LED OFF)
Color select
(LED ON)
Show select
(LED slow blinking)
Chase select
(LED fast blinking)
D. Connect an optional JBS LEDCON-02 controller for more control:
The JBS LEDCON-02 controller can only be used in standalone or master/slave mode. Connect the
controller to the DMX-input of the first unit (master). Make sure that the LDP-ACCUSPOT projectors are
all set to channel mode1 (Md 1). Now you can control all the connected units in 4 or 8channel mode.
Refer to the user manual of the JBS LEDCON-02 controller for more information and automatic
addressing.
E. Controlled by universal DMX-controller:
 Connect all units together. Refer to the chapter “Electrical installation for two or more units in DMX-
mode” to learn how to do this (don’t forget to address all units properly!)
 Turn on the DMX controller.
Since each unit has its own DMX-address, you can control them individually. Remember that each unit
uses 4 or 6 DMX-channels as shown in the DMX chart below:
Channel modes 1 + 2 + 3 + 4:
Channel4 can have 4 different behaviors, depending on the channel mode (1,2,3 or 4) you selected.