User Manual
Table Of Contents
ENGLISH USER MANUAL
Briteq
®
4/12 BT-AKKULITE IP MINI
ELECTRICAL INSTALLATION
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Note: In the explanations below we assume that you will operate the projectors with the internal battery
which is already fully charged. If you want to use them with a mains cable, simply connect all projectors to
the mains using the supplied power cable.
Electrical installation for 1 standalone unit:
• Switch the projector on using the power switch (5). The unit starts working immediately in the last
selected stand-alone mode.
• Refer to chapter [SETUP MENU] to learn how to switch between different working modes.
Electrical installation for two or more units in master/slave:
• Make sure that all units are switched on.
• Setup 1 unit as Master (see [SETUP MENU]) and wireless transmitter (see [SETUP FOR WIRELESS
OPERATION]). Setup the other units as Slave (see [SETUP MENU]) and wireless receiver (see [SETUP
FOR WIRELESS OPERATION])
• Done
Remark: You can connect a JB Systems LEDCON-02 Mk2 or Ledcon XL remote controller to the master
unit if you want to have more control over the master/slave operation.
WIRELESS SOLUTION
• Switch all projectors on.
• Put all projectors in the desired DMX-channel mode (see chapter [SETUP MENU]: option [CHnd])
• Set the desired DMX start address on all projectors, take in account the number of DMX channels used
by the selected DMX-channel mode! (see chapter [SETUP MENU]: option [Addr] )
• Switch on the wireless mode using button (2).
• Synchronize all projectors with the wireless DMX transmitter. (for example : Briteq
®
“WT-DMXG4”
transmitter is 100% compatible) (see chapter [SETUP FOR WIRELESS OPERATION])
• Once this is done everything should work.