FEDERAL COMMUNICATIONS COMMISSION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection.
°F (oni OF Vulcan G 3D Game Accelerator 1. INTRODUCTION The Vulcan G Game Accelerator has been implemented with Dix's Interactive Voodoo Graphics game accelerator. That provides the highest performance 3D solution with full PC compatibility for multimedia graphics acceleration. 1.
Vulcan G 3D Game Accelerator hardware Information 2.1 Configuring the Vulcan G MONITOR + T™U VGA INPUT FBI u1é U2 uis U1 u12 uti ut U4 u17 u3 uto us | VGA CARD 2.2 Understand your Vulcan G + Monitor Connector: This connector accepts the video cable from the monitor, where the Vulcan G accelerator is attached. 2 VGA input Connector: This connector accepts the Video cable from the VGA card (The cable is bundled in BOX). 2.
“fe I ror Vulcan G 3D Game Accelerator 3 SOFTWARE UTILITIES To facilitate the smooth installation of the optimized display drivers and utility software provided with your multimedia accelerator, you should read the instructions in this section carefully prior to attempting installation. The optimized display drivers for your multimedia accelerator may have been provided on diskette or compact disk (CD).
Fu TOR Vulcan G 3D Game Accelerator 3.3.1 DOS Notes If you are running within pure DOS (not a DOS Prompt or DOS Shell under Windows for Work groups, Wing, or 0S/2) and you have less than 24MB of RAM you must set the environment variable DOSAGE to DOS4GVM=1} the value 1. 3.3.2 Windows 95 Notes If you are running under Wing and you have less than 24MB of RAM you must change your DOS properties settings. The value for DPI memory must be changed from AUTO to 16384.
Vulcan G 3D Game Accelerator HAL. The driver is compatible with Direct X. Please obtain a release of this software if you require DirectDraw/Direct3D acceleration. 3.1.2 Directed The driver contains a Directed HAL driver. This enables hardware acceleration of Directed applications. Some features are currently still under development and there are limitations which should be understood before attempting to run Directed or Regained Mode Directed programs.
Strop Vulcan G 3D Game Accelerator 3. Locate an available (unused) expansion slot. Your Vulcan G Game Accelerator can be installed in any PCI expansion slot. Remove the slot cover and save the screw to anchor the accelerator board mounting bracket later. . Pick up the board (still in its sleeve) by grasping the edge bracket with one hand. Avoiding pressing on board components. With your other hand, touch an unpainted metal surface to discharge any built-up static electricity in your body.
Foppish Vulcan G 3D Game Accelerator 1.4 System Requirements 120MHz (or faster) Intel Pentium™ CPU Vacant PC! slot Minimum 16MB RAM, 32MB Recommended For Glide: MS-DOS® revision 6.22 or higher, Windows® 95 or Windows® NT 4.0 For Direct3D/DirectDraw (Windows ®95 or Windows ®98) 1.5 Advanced Information For more information, please refers to 3Dfx web site at: 3dfx.
1 ra CONTENTS INTRODUCTION. 11 GENERAL FEATURE DESCRIPTION. 12 3D FEATURE DESCRIPTION 13 SOFTWARE DRIVERS LIST 14 SYSTEM REQUIREMENTS .. 15 ADVANCED INFORMATION . HARDWARE INFORMATION... 21 CONFIGURING THE VULCAN G 22 UNDERSTAND YOUR VULCAN 23 VGA CARD INSTALLATION. SOFTWARE 3.1 WOWS 93 INSTALLATION 3.31 DOS Notes. . Windows 95 Notes... Windows NT Notes 34d Direct Draw. EN Directed 4 313 Other APL 6 32 Powwows NT ..6 33 GLIDE 3D DRIVER...
