User guide

28 29
Positioning and Securing Your Child with Backrest
and Lap-shoulder Belt Only
 Before using the booster seat for the first
time, you will need to complete the assembly
instructions on page 14.
1 Place the booster seat on the vehicle seat.
2 Push the backrest until it rests against the
vehicle seat back (Fig. A). If the vehicle seat
back is adjustable, move it to the normal upright
position.
NOTE: If needed, adjust or remove the vehicle’s
head restraint to allow the backrest to lie flat
against the vehicle’s seat back.
3 Sit your child in the booster seat and check the
head restraint for proper height adjustment (Fig.
B).
a
b
Positioning the Booster Seat

9 If the vehicle seat back is adjustable, ensure it is in the upright
position before placing the booster seat on the vehicle seat.
9 Adjust the head restraint appropriately to fit child (see page 17).
Positioning the Booster Seat
4 Pull the vehicle seat belt out and route the
shoulder part of the vehicle seat belt through
the upper belt guide (Fig. C).
5 Route the lap part of the vehicle seat belt under
both armrests, over your child’s upper thighs
and over both red belt guides (Fig. D).
6 Verify that the vehicle seat belt is not twisted
and then fasten the vehicle seat belt across the
child (Fig. E).
7 Route the lap part of the vehicle seat belt
through the SecureGuard™ clip (Fig. I).
* The lap part of the vehicle seat belt should
rest low on the child’s upper thighs.
8 Remove slack from the vehicle seat belt.
* The shoulder part should cross the chest in
the center of the child’s collar bone.
c
e
d
f
Checklist
9 Vehicle seat belt is not twisted
9 Vehicle seat belt is securely fastened
9 Shoulder part of the vehicle seat belt is routed
through the shoulder belt guide
9 Lap part of the vehicle belt is routed through the
SecureGuard™ clip
9 Vehicle seat belt is properly positioned low
across the child’s upper thighs and does not
contact the child’s neck