Instruction manual

Instructions for Installation & Use - Series No. 4900/A/2010
40
ONLY USE A 5/16 UNC GRADE 5 BOLT. IF THE
BOLT IS NOT THE CORRECT LENGTH THE CAR
MANUFACTURER’S HAND BOOK CAN PROVIDE
ADVICE ON THE CORRECT LENGTH BOLT.
Note: Marking on
the top of a Grade 5
Bolt.
Front of Vehicle
Centre line of
seating position
Fig.3.
CHILD RESTRAINTS MUST NOT BE ATTACHED
TO UNSOUND METAL OR TO WOOD, OR
SYNTHETIC STRUCTURES. WHEN DRILLING
9 MM HOLE DO NOT DRILL THROUGH FUEL
LINES, FUEL TANKS, ELECTRICAL WIRING, OR
RADIO SPEAKERS.
WEBBING STRAPS MUST BE PROTECTED FROM
SHARP CORNERS AND EDGES. THE ANCHOR
FITTING MUST BE USED ONLY AS DESCRIBED
ABOVE. IT MUST NOT BE HOOKED ONTO ANY
OTHER OBJECT.
CAR INSTALLATION ACCESSORIES
(From retailers of Safe-n-Sound products)
EXTRA ANCHOR KITS: Available for using the restraint in additional cars.
Re-order no: 0038
EXTENSION STRAPS: May be required for cars without a xed parcel shelf.
Re-order no: 0035 (length 300mm) or 0036 (length 600mm)
GATED 3-BAR SLIDE (Locking clip): For converting lap-sash seatbelt to lap belt, for use
with a Child Harness. May be required for a second car. Re-order no: 0215.
200mm
min.
INSTALLATION OF CAR ANCHOR FITTING