Instruction manual

Instructions for Installation & Use - Series No. 4900/A/2010

C. Replace middle cover, tuck in

plastic aps from both ends

of the booster wings (see

illustration). Do not loop elastic

at the bottom of the middle cover

over the booster seat, this is

placed at the front of the middle

cover. Feed elastic through the

wings (see illustration). Insert

cover into the channel running

along the edge of the wings.

B. To replace headrest, adjust the headrest height

to the highest position. Pull elastic over the air

cushions and tuck behind. Attach the elastic

loops to the hooks at the back of the red sash

guides. Ret cover around headrest. Ensure that

the headrest is tucked in the channel around the

red sash guides, so that the sash guide text is

clearly visible.

TO REPLACE COVER

A. To replace base cover, Slide on base cover and

feed through SLIDEGUARD™clip and the knob

then loop elastic over the back of the base.

Tuck Plastic

Flaps in slots

Replace elastic from

behind air cushion

Hook elastic behind headrest

Feed the

SLIDEGUARD™clip

through slot

Feed the knob

through slot

D. Replace cup holder if needed.

Hook elastic from underneath booster

Feed cover

into channel

Tuck Plastic

Flaps in slots

CARE & MAINTENANCE