Instruction manual

Instructions for Installation & Use - Series No. 4900/A/2010
D. Engage the seatbelt tongue to the buckle and
adjust the seatbelt to sit rmly but comfortably
around the child's pelvis. The seatbelt buckle
should be located as low as possible below the
child's hip.
E. With the lap belt (or converted lap/sash)
adjusted to be a rm t on the child's thighs,
then adjust the Child Harness to remove slack
in the shoulder straps. Pull the Adjuster Strap
(C) to remove slack.
Once adjusted correctly, further adjustments
to the harness or extension strap may only be
necessary only to the upper extension straps
and to accommodate the growth of the child.
Press (A) and pull the shoulder strap (B) to
lengthen.
G. Finally, roll up the free end of the adjuster strap,
secure using the storage strap, then place it into
the top of the adjuster cover as shown right.
29
HOW TO INSTALL WITH A CHILD HARNESS
E
Fully press adjuster button
(A) while pulling the Upper
Anchorage Strap (B) to lengthen.
B
C
A
Adjuster
Pull Adjuster
strap to
remove
slack
Fold the
adjuster strap
and secure
with Storage
Strap.
Adjuster
Cover
Storage Strap
The lap portion of the belt must be adjusted rmly rst, and then the harness, so that
the belt is not lifted off the child's lap when the harness is adjusted.
CAUTION:
NOTE: The shoulder straps must be in the slots which are nearest to the child’s
shoulders but not lower than the child’s shoulders. This is achieved with the headrest
slightly above the child’s shoulders.