4 Wheel Travel System Stroller SUITABLE FOR USE WITH THE STEELCRAFT INFANT CARRIER (SOLD SEPARATELY) IMPORTANT: KEEP THIS BOOKLET IN A SAFE PLACE FOR FUTURE REFERENCE. Serial No.
CONTENTS PAGE Warnings................................................................................................. 3 Parts List ................................................................................................ .6 Assembled Stroller Parts List....................................................................7 01. To Open Stroller .................................................................................8 02. To Assemble And Remove The Front Swivel Wheels ........................
WARNINGS • RETAIN FOR FUTURE REFERENCE. • READ ALL INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY AND USE OF THIS STROLLER. ALWAYS FOLLOW THE INSTRUCTIONS. • THE CORRECT USE AND MAINTENANCE OF THIS PRODUCT IS ESSENTIAL. WARNINGS: TO AVOID INJURY OR DEATH: ALWAYS APPLY THE BRAKES WHENEVER THE STROLLER STATIONARY. • • • • • • • • • • • • FOLLOW THE MANUFACTURERS INSTRUCTIONS. DO NOT LEAVE CHILDREN UNATTENDED. SECURE THE CHILD IN THE HARNESS AT ALL TIMES. DO NOT CARRY EXTRA CHILDREN OR BAGS ON THIS STROLLER.
WARNINGS WARNING • Do not allow children to stand on the seat. • Do not hang bags or goods from the handle as this could cause the stroller to tip over. • To prevent the risk of the stroller catching fire, do not park it near an exposed heat source such as a radiator, an open fire or a barbecue, etc. • Do not run while using this product. • Always lock swivel wheels when on rough surfaces as this will help eliminate wheel wobble.
WARNINGS IMPORTANT • The upright positions are not suitable for use with children less than six months old. The lowest recline position should be used to transport babies, and the backrest can be adjusted to a more upright position as the child grows older and is able to support its head without assistance. SAFETY WARNINGS • The sun is very strong. DO NOT LEAVE YOUR CHILD EXPOSED TO THE SUN. The canopy or hood on this product will not give your child total protection from the harmful rays of the sun.
PARTS LIST A B D E G H A B C D 6 C F I 1 x Stroller Frame, Seat & Basket 1 x Canopy 2 x Rear Wheels 2 x Front Wheels Accessories E F G H I www.britax.com.
ASSEMBLED STROLLER - PART LIST Adjustable Handle Canopy Tether Strap Front canopy tube Upper seat Child Centre Tray Shoulder Pads Harness Lower seat Sure Lock release button Leg rest Rear leg tube Front leg tube Front Wheel release button Basket Front Wheel swivel lock Canopy window Canopy window cover www.britax.com.
01. TO OPEN STROLLER A Release the storage latch (1) located on the rear leg. Open the frame as shown by the arrows (2) until you hear a ‘click’ which indicates the frame is fully opened and locked. Push down on the stroller handle to confirm that frame is locked 2 1 Storage latch 2 2 A 02.
03. TO FIT AND REMOVE THE REAR WHEELS A To fit the rear wheels, insert each wheel axle into the moulding and push in until locked. You should hear a ‘click’ which indicates the wheel has locked in. Pull on the wheel to make sure it is engaged. Repeat the process if not locked in. B To remove the wheels, pull the metal latch downwards on the underneath of the brake moulding to release the wheel, and then pull the wheel off. A B Metal Latch 04.
05. TO ATTACH AND USE THE CANOPY A1 To attach the canopy, insert the canopy mouldings into the frame mouldings until they connect together. The back flap of the canopy can be attached to the main canopy with the zipper attachment. A A2 Attach the snaps located on the straps on the sides of the canopy to the top of the handle tubes, then fold the strap up under the canopy back flap and secure strap with hook and loop to the underneath of the canopy. 10 www.britax.com.
05. TO ATTACH AND USE THE CANOPY (Cont) A3 Fold the backflap over the back of the stroller. Attach the hook square on the inside of the canopy back flap to the loop strip on the side of the stroller. A4 Attach the hook strip on the inside edge of the canopy to the loop strip on the side of the stroller. B To remove the canopy, press in the button on the canopy moulding and pull out of the frame mouldings. The button on the canopy moulding B www.britax.com.
05. TO ATTACH AND USE THE CANOPY (Cont) C To adjust the canopy, open by pulling forward, or close by pushing it backward. C D To open the canopy window lift the canopy window flap away from the canopy. Canopy window Canopy window flap Canopy back flap zipper D E For additional air circulation the back flap of the canopy can be removed by opening the zipper. To reattach the back flap to the main canopy secure with the zipper. E 12 E www.britax.com.
05. TO ATTACH AND USE THE CANOPY (Cont) F You can also fold up the back flap and secure with the toggle and elastic. F 06. TO ATTACH AND USE CHILD TRAY WARNING: WHEN A CHILD IS IN THE STROLLER KEEP THE CHILD TRAY ATTACHED TO THE ADAPTORS AT ALL TIMES. Stand beside of the stroller & pull the fabric back from the sides of the stroller to expose the stroller hinge. Take one chld tray adapter at a time & insert the adaptor into the stroller hinge as shown.
06. TO RELEASE THE CHILD TRAY To release the child tray pull the grey tab underneath the tray and rotate the tray. To remove the child tray push the grey tabs on the adaptors and lift the adapters and tray until it is removed. 07. TO ADJUST THE BACKREST WARNINGS: ENSURE THAT YOUR CHILD’S LIMBS ARE IN THE CENTRE OF THE SEAT AND SUPPORT YOUR CHILD’S WEIGHT WHEN USING THE BACKREST.
08. TO USE THE BRAKES WARNINGS: ALWAYS APPLY THE BRAKES WHEN THE STROLLER IS NOT MOVING. THE STROLLER MAY ROLL AWAY EVEN IF LEFT UNATTENDED FOR A FEW MOMENTS. A To lock the rear wheels, press down on the brake pedal. Check that the brake has locked by trying to push the stroller forward. If not locked, repeat this step. B To release the brake, push up on the pedal. Brake Pedal 09. TO ADJUST THE FOOTREST Lower the footrest by pressing on release buttons on both sides of leg support.
10. TO ADJUST THE PIVOT HANDLE To adjust the handle height, squeeze in and hold the buttons on the inside of the handle. Rotate the handle up and down to the desired position. When the desired position has been achieved, release the buttons. 11. TO SECURE YOUR CHILD IN THE HARNESS WARNINGS: USE THE HARNESS AT ALL TIMES. When not in use disconnect shoulder straps from the waist strap and buckle to prevent strangulation. A five point harness is provided to restrain your child.
11. TO SECURE YOUR CHILD IN THE HARNESS A Position the shoulder strap tongue (A) on the top of the waist buckle tongue (B) on both sides. Shoulder strap A A Buckle housing Waist B strap C Waist strap B Crotch strap B Push both buckle tongues (A+B) into the buckle housing (C) until the buckle tongues lock into position. Shoulder strap Shoulder strap Buckle housing Waist strap A+B C A+B Crotch strap C Tighten or loosen shoulder and crotch straps by sliding up and down the 3 bar sliders.
11. TO SECURE YOUR CHILD IN THE HARNESS D Tighten or loosen the waist straps, hold and lift the 4 bar slider and then pull the harness strap, to adjust to the desired fit. The waist strap needs to fit firmly around the child. E 4 bar slider Tighten or loosen the shoulder straps, slide the 3 bar slider up or down to adjust to the desired fit. Always adjust the harness strap when changing the seating position of the child. CAUTION: DO NOT SLIDE 3 BAR SLIDER OVER THE SEWN TAB ON SHOULDER HARNESS 18 www.
11. TO SECURE YOUR CHILD IN THE HARNESS F To release the buckle. Squeeze the top and buckle tongues together with enough pressure so the buckle tongues can release from the buckle housing. G The stroller seat has *2 or 3 sets of harness slots at different heights to accommodate the child. To change the shoulder harness height, push the shoulder harness tongue out of the current harness slot and through the back of the seat. * Depending on the model www.britax.com.
12. TO USE THE TETHER STRAP WARNING: USE THE TETHER STRAP TO PREVENT THE STROLLER ROLLING AWAY. A A wrist tether strap is provided on the handle grip. Slide your hand through the tether strap loop whenever you use the stroller. Only remove your hand from the tether strap loop when the brakes have been applied to the stroller wheels. 13. TO FIT THE RAIN COVER A Pull the rain cover over extended canopy and push the back flap of rain cover through the handle opening. 20 www.britax.com.
13. TO FIT THE RAIN COVER (cont) B To secure the rain cover, (B1)attach the hook and loop strips on the sides of the rain cover. (B2) Now attach the hook and loop straps on the front of the rain cover around the wheel moulding above the swivel wheel lock. B1 B2 B2 14. TO USE THE STROLLER • With your hand through the wrist tether strap loop, push the stroller holding the handle. • The stroller can be steered in the desired direction - allowing the front wheels to swivel will make this easier.
15. TO FOLD THE STROLLER A Tuck the bottom of the canopy backflap into small mesh pocket. Close canopy. Canopy back flap B B Before folding stroller ensure footrest is in the lowest postion. C Ensure the pivitol handle is in the highest postion. 22 www.britax.com.
15. TO FOLD THE STROLLER (cont) D Press the RED Sure Lock release button (1) located on the right hand side of the stroller. With the other hand pull up the folding strap (2) as shown by the arrow. The stroller will now fold. D E D Lock the frame together with the storage latch. A carry handle is supplied for ease of transport when stroller is fully folded. Only use the handle to carry the stroller. Storage latch E F E Once folded the stroller stands in an upright position. F www.britax.com.
16. TO FIT THE REVERSIBLE SEAT INSERT Release harness buckles and thread the shoulder and waist harness straps through the appropriate slots. Thread the harness pads through the sholder strap. NOTE: Attach the hook and loop on top rear of seat pad to top of backrest. 17. TO FIT BOOTCOVER Raise leg support, hook bootcover product under the leg support and pull bootcover under the child tray. Connect the hook and loop around stroller frame. 24 www.britax.com.
18. INSTALL THE INFANT CARRIER (Sold Separately) WARNINGS • THE STEELCRAFT INFANT CARRIER IS THE ONLY INFANT CARRIER DESIGNED TO FIT THIS STROLLER. • THE INFANT CARRIER MUST BE CORRECTLY FITTED AND LOCKED ONTO THE STROLLER. • THE INFANT CARRIER MUST ONLY BE USED IN THE REARWARD FACING POSITION, FITTED TO THE STROLLER FACING TOWARD THE STROLLER HANDLE. • SECURE THE CHILD IN THE HARNESS AT ALL TIMES. • DO NOT LEAVE THE CHILD IN THE INFANT CARRIER FOR EXTENDED PERIODS.
18. INSTALL THE INFANT CARRIER (Sold Separately) A Stand in front of the stroller and pull the fabric back from the sides of the stroller to expose the stroller hinge. Take one Infant Carrier adaptor at a time and insert the adaptor into the stroller hinge as shown. Push on the adaptor until you hear a ‘click which indicates the adaptor has locked in. Pull up on each adaptor to check they have fully locked in. Adapter A Please Note: Fit adaptors standing in front of the stroller.
18. INSTALL THE INFANT CARRIER (Sold Separately) C Lower the Infant Carrier into the adaptors. Press down firmly on both sides. C D The Infant Carrier now needs to be locked securely into the adaptors. Squeeze in and hold the latches on either side of the handle, rotate the handle backwards. The GREEN indicator will now turn to RED. Handle latch Indicator D www.britax.com.
18. INSTALL THE INFANT CARRIER (Sold Separately) E Release the handle latches. Then with one hand holding the front of the Infant Carrier, push the Infant Carrier handle all the way down until you hear it lock into the adaptors. The handle indicator should now be GREEN and the Infant Carrier should be locked into the adaptors. If the indicator is RED the Infant Carrier handle is not in the locked position, repeat step D.
19. TO RELEASE THE INFANT CARRIER A To remove the Infant Carrier, squeeze both handle latches in to release the locks. The indicator will now be RED. Indicator Handle latch A B Continue to rotate the handle forward until it returns to the upright position. Release the latches, the indicator should now be GREEN. Handle latch Indicator B www.britax.com.
19. TO RELEASE THE INFANT CARRIER C Lift and remove the Infant Carrier away from the stroller. C D To remove the adaptors, press the red button in on the inside of the adaptor and pull the adaptor up. Adapter Red Button D 30 www.britax.com.
CARE AND MAINTENANCE • To prolong the life of your stroller keep it clean and do not leave it in the direct sunlight or in the car boot for extended periods of time. • Removable fabric covers and trims may be cleaned using warm water with a household soap or mild detergent. Allow it to dry fully, preferably away from the direct sunlight. • Non removable fabric covers and trims may be spot cleaned using a damp sponge with soap or a mild detergent. Allow it to dry completely before folding or storing it away.
BRITAX CHILDCARE PTY. LTD A Britax International company. (Incorporated in Victoria) A.B.N. 55 006 773 600 99 Derby Road, Sunshine, Victoria, 3020, Australia Phone: (03) 9288 7288 Fax: (03) 9311 5798 Due to our continuing program of development, Britax Reserves the right to alter these specifications, colour or design without any further notice. The Steelcraft trademark is the property of Britax Childcare Pty. Ltd - Australia.
