User guide

31Installing the Base
Follow the steps below if adjustment of the recline angle is
necessary:
a Unbuckle the seat belt.
b Turn the recline adjustment knob
to adjust the recline angle.
c Place the infant carrier in the base and check the recline angle.
Repeat the previous steps until a secure installation with proper recline
angle is achieved. Continue with installation instructions from step 3.
If there is a problem achieving the proper recline angle after
following the previous steps:
d Uninstall the base and rotate the recline adjuster on the base to the
lowest position.
e Remove the base from the vehicle seat.
f Place a rolled towel or pool
noodle in the vehicle seat bight.
g Place the base on the towel or
pool noodle to help level the
base and continue installation
from step 3 on page 28.