User guide

5 Push the base firmly into the

vehicle seat while removing

all slack from the vehicle belt.

6 Route any excess webbing

from the vehicle belt through

the lock-off.

7 Close the lock-off plate over

the webbing and close both

lock-off tabs while pressing

firmly on the lock-off plate.

* The lock-off is properly secured

when the tabs lay flat against

the lock-off plate.

* If the lock-off will not close,

remove the excess vehicle belt

webbing and tuck it under the

base.

Installing the Base

9 Verify that the vehicle belt is tight and that the base is secure. The

base is secure when it moves less than 1 inch (2.5 cm) front-to-

back or side-to-side at the vehicle belt path.

8 Place the infant carrier into

the base and press down until

a click is heard.

* Pull up on the carrier handle to

confirm attachment.