User guide

52
53
Detach the Versa-Tether1
®
hook
from the storage clip.
Ensure the positioning block
2
is rotated to the back.
Place the child seat on the
3
vehicle seat and connect the
LATCH connectors to the
vehicle LATCH anchors.
Push the child seat into the
4
vehicle seat and pull the end
of each LATCH strap through
the belt slot to remove slack.
Repeat as necessary. Store *
excess webbing behind cover.
Using LATCH
Positioning the Child Seat: Booster ModePositioning the Child Seat: Booster Mode
Before you begin:
Does your vehicle have a top tether anchor in the chosen seating 9
position?
Does your vehicle have LATCH anchors in the chosen seating position? 9
IMPORTANT: Use LATCH only to position this child seat to your vehicle
seat. Secure your child using the vehicle’s lap-shoulder belt system.
WARNING!
Position forward-facing • only in a seating position with a
lap-shoulder belt.
Use • only the vehicle’s lap and shoulder belt system when
securing a child in booster mode. Never secure a child
with a lap belt only in booster mode.
Always• secure the unoccupied child seat.
If the LATCH anchors in your vehicle prevent proper •
vehicle belt fit across your child you cannot use LATCH to
position this seat in booster mode. See below.
The vehicle belt fits properly
when the lap part sits low across
the child’s hips (a) and the
shoulder part lies across the
child’s shoulder and does not
contact the child’s neck when
routed through the upper belt
guide (b).
a
b