Instructions / Assembly

10
Test the Filter System
Step 4
whole house filtration system
• Slowly turn on water supply.
• Press red pressure-relief button to
release any trapped air.
• Check for leaks.
• Turn on the nearest faucet and flush
system for 40 minutes.
whole house filtration system
» If leaks continue, turn o the water supply and call
Customer Service or your local plumber.
Leaks between system
head assembly and
filter housing
* Turn o main water supply to home.
* Purge water from lines by turning on all faucets
and drain lines completely.
* Press red pressure-relief button on system
head to release pressure.
* Unscrew and remove system head using filter
housing wrench.
* Remove black o-ring and inspect. Clean and
lubricate with silicone grease.
* Clean grooves in top of filter housing where the
o-ring sits.
* Place the clean, lubricated o-ring back in the
groove.
* Screw filter housing back onto the system head
and hand-tighten. DO NOT OVERTIGHTEN.
Troubleshooting
Guide
* Turn o the main water supply.
* Purge water from plumbing lines by turning on
all faucets in your home and draining completely.
* Tighten all fittings.
* Turn on the main water supply, and inspect for
leaks.
* If leaks continue, disassemble the configured
system, reapply plumber's tape or sealant, and
reinstall the filter system.
Leaks around fittings
Note: Place paper towels or rag under the filter
system to catch any water drips.