Instructions / Assembly

9
Version 2.0GWHS-101 Installation Instructions
• Turn off household water supply to the home.
• Turn on all faucets in home to drain water lines.
Before You Begin
• Rinse filter housing.
• Fill 1/3 with water and add 2 tbsp. of Clorox® bleach.
• Wipe Head and Housing.
• Rinse Filter Head thoroughly to remove bleach.
Step 2
Clean
Filter Housing
• Insert new Filter over standpipe in bottom of
Housing.
• Attach Housing to Head and hand tighten.
• Using the Wrench, tighten 1/4 turn.
DO NOT OVERTIGHTEN.
Step 4 Insert New Filter
• Press the red pressure relief button.
• Use the wrench to remove the filter housing.
• Careful: Filter housing will contain water.
Step 1
Unscrew
Filter Housing
• Remove and wipe clean o-ring.
• Lubricate o-ring with silicone grease.
• Return o-ring and seat securely for a good seal.
Step 3
Clean and
Lubricate O-Ring
• Slowly turn on household water supply.
• Check for leaks.
•
Press red pressure relief button to release trapped air.
• Open the faucet and flush for 40 minutes.
Step 5 Flush New Filter
household filtration
» If leaks continue, turn o the water supply and call
Customer Service or your local plumber.
Filter Replacement
(every 6 months)
household filtration
9
Note: Place paper towels or rag under the filter housing to catch any water drips.
*Note: To prevent leaks and/or housing ruptures, please properly seat filter cartridge at top and bottom within filter housing.
For FREE Filter Replacement Reminder, go to www.protectplus.com
* Turn o household water supply.
* Purge all water from the water lines by
turning on all faucets in your home and drain
completely.
* Press the red pressure-relief button on top of
the housing head to release pressure.
* Unscrew and remove the housing head from
the housing using the Filter Housing Wrench.
NOTE: Use a bucket to catch any water in the
housing.
* Remove the black O-Ring and inspect. Clean
and lubricate with silicone grease.
* Clean the groove in the top of the filter housing
where the O-Ring sits.
* Place the clean, lubricated O-Ring back in the
groove.
* Screw the filter housing back onto the housing
head and hand-tighten. Using the Filter
Housing Wrench, tighten 1/4 turn.
NOTE: Do not over tighten.
* Turn on the household water supply and
inspect for leaks.
* Turn o the household water supply.
* Purge all water from the water lines by
turning on all faucets in your home and drain
completely.
* Tighten all fittings.
* Turn on the household water supply and
inspect for leaks.
* If leaks continue, disassemble the configured
unit, reapply plumber's tape or sealant, and
reinstall the Filter.
R
E
P
L
A
C
E
E
V
E
R
Y
S
I
X
M
O
N
T
H
S