Instructions / Assembly

10
Test the Filter
Step 4
household filtration
• Slowly turn on water supply.
• Press red pressure-relief button to
release any trapped air.
• Check for leaks.
• Turn on the nearest faucet and flush
for 40 minutes.
household filtration
» If leaks continue, turn o the water supply and call
Customer Service or your local plumber.
Leaks between
head assembly and
filter housing
* Turn o household water supply.
* Purge water from lines by turning on all faucets
and drain lines completely.
* Press red pressure-relief button on housing
head to release pressure.
* Unscrew and remove housing head using filter
housing wrench.
* Remove black o-ring and inspect. Clean and
lubricate with silicone grease.
* Clean grooves in top of filter housing where the
o-ring sits.
* Place the clean, lubricated o-ring back in the
groove.
* Screw filter housing back onto the
housing head and hand-tighten.
DO NOT OVERTIGHTEN.
Filter Replacement
(every 3 months)
household filtration
Troubleshooting
Guide
* Turn o the household water supply.
* Purge water from water lines by turning on
all faucets in your home and draining completely.
* Tighten all fittings.
* Turn on the household water supply, and inspect
for leaks.
* If leaks continue, disassemble the configured
unit, reapply plumber's tape or sealant, and
reinstall the filter.
Leaks around fittings
For FREE Filter Replacement Reminder, go to www.protectplus.com
Note: Place paper towels or rag under the filter
to catch any water drips.