Instructions / Assembly

9
Version 2.0A
USS-335 installation instructions
• Choose an easy-to-access area under the sink to mount RO System Head.
• Mark holes for mounting screws on the wall surface using the built-in bracket on
back of the RO System Head as a guide.
• Drill two pilot holes for the mounting screws. Insert mounting screws into the
wall with a phillips screwdriver, leaving approximately 3/8" of each mounting
screw exposed.
• Hang the RO System Head on the mounting screws.
Note: To allow adequate space for filter changes, allow a minimum clearance of 4" to 6" below the filter to the
floor. The filter System Assembly must be mounted in a vertical position.
Note: Mount Filter System Head to a solid cabinet wall or wall. If a solid surface is not available, use hollow-wall
anchor bolts or toggle bolts (not included) to secure to the wall.
Mount the Reverse Osmosis Filter System Assembly Head using the two mounting screws. The mounting screws allow
you to lift the RO Filter System Assembly without any hardware removal.
Step 3
Install RO Filter System
Assembly
connect to auxiliary faucet
materials and tools needed
WARNING
4-6" FROM BOTTOM
Mount to
cabinet in
vertical
position
safety glasses
drill
phillips
screwdriver