Instructions / Assembly

• Remove protective cover from back of foam seal. Knock out center hole and align
holes then attach to drain connector front plate.
• Position the drain connector on the sink drain pipe above the drain trap. Allow
room for drilling. Tighten screws and nuts securely.
• Using the drain connector port as a drill guide, drill a 7/32" hole through the wall of
the drain pipe. DO NOT penetrate the opposite side of the pipe, and be careful not
to damage the side of the drain port fitting.
Note: Extra care should be taken when entering drains near dishwashers or food waste disposals, as backflow
may occur through the air gap and cause flooding.
materials and tools needed
safety glasses
drill
DRAIN CONNECTOR INSTALLATION
Step 2
Install RO Drain
Connector
connect to auxiliary faucet
8
WARNING
CAUTION
FOAM
SEAL