Instructions / Assembly

14
Step 6
Connect Water Lines
connect to auxiliary faucet
Air Gap from Faucet to RO Assembly
• Locate 1/4" Red Plastic Tubing already attached to
air gap barb on RO Faucet Body.
• Determine length necessary to connect to drain
outlet on RO Membrane Filter.
• Cut 1/4" Red Plastic Tubing square and to length
with sharp utility knife.
• Insert Restrictor into end of 1/4" Red Plastic Tubing.
• Remove black plug from RO Membrane Filter drain
port by pushing on white collar while pulling plug
with other hand. Discard plug.
• Insert 1/4" Red Plastic Tubing all the way into fitting
on bottom of RO Membrane Filter approximately
5/8" until it stops.
• Pull on 1/4" Red Plastic Tubing to be sure it is held
firmly in fitting.
Note: Tubing lengths should allow for the removal of the assembly from the mouting screws for servicing. If tubing lengths
are shortened for neater appearance, it may be necessary to keep the assembly on the mounting screws for service.
Note: Codes in the state of Massachusetts require installation by a licensed plumber and do not permit the use of
saddle valves. If you live in the state of Massachusetts, review plumbing code 248-CMR of the Commonwealth of
Massachusetts before proceeding with the installation.
*Note: System will NOT operate without Restrictor.
*RESTRICTOR
Connect 3/8" Red Tube from Reverse Osmosis Faucet to Drain Adapter
• Locate 3/8" Red Plastic Tubing already attached to
RO Faucet Body.
• The other end needs to be attached to collet on sink
Drain Connector.
• Cut 3/8" Red Plastic Tubing as needed to route in as
straight of a run as possible, without loops, dips, low
spots, or kinks.
• Cut end of 3/8" Red Plastic Tubing square with a
sharp utility knife.
• Insert all the way into fitting approximately 1" until
it stops.
• Pull on tube to be sure it is held firmly in fitting.
FAUCET
TANK
Step 6 continued on next page >>
<< Step continued from previous page