Instructions / Assembly

10
Install Redi-Twist

Filters
and Test for Leaks
Step 4
connect to auxiliary faucet
• Hold the Redi-Twist™ filter with the
label facing you.
• Insert filter up into the system head
until the two nozzles seat into the ports.
• Turn the Redi-Twist™ filter from left
to right (as you face it) until it stops.
• Turn on the cold water shut-o valve.
• Turn on the new faucet. Allow
the water to run for approximately 10
minutes.
• Check for any leaks.
• If system is leaking, turn o cold
water shut-o valve and refer to
troubleshooting guide.
Filter Replacement
(every 6 months)
connect to auxiliary faucet
R
E
P
L
A
C
E
E
V
E
R
Y
S
I
X
M
O
N
T
H
S
• Turn the Redi-Twist™ filter right to
left (as you face it) until it releases.
Remove and discard used Redi-
Twist™ filter.
• See Step 4 for inserting new filter.
• Changing water filter on a regular
basis ensures optimum performance
of the water filtration system.
• Note date filter is installed on
cartridge tank label.
For FREE Filter Replacement
Reminder, go to
www.protectplus.com
LOCK LOCK
1st Stage
Carbon
2nd Stage
Carbon
Note: Place paper towels or rag under the filter
system to catch any water drips.
Note: The 1/4" plastic tubing does not need to
be disconnected for general routine maintenance
and filter replacement. However, plastic tubing
may be easily disconnected. Simply turn o the
water supply to the filter system. Press in the
gray collar around the fitting while pulling the
plastic tubing out with the other hand.
* Microbiological filter cartridge ALWAYS in this position
1/4 turn
LOCK LOCK
LOCK LOCK
1/4 turn
Align Arrow
LOCK LOCK