Instructions / Assembly

8
Test the Filter System
Step 4
whole house filtration system
• Turn valve lever on system head to
"o" position.
• Turn on water supply.
• Slowly turn valve on system head to
"FILTER" position. The red indicator
should line up with "FILTER" on
system head.
• Check for leaks.
• Turn on the nearest faucet and flush
system for 40 minutes.
whole house filtration system
» If leaks continue, turn o the water supply and call
Customer Service or your local plumber.
Leaks between system
head assembly and
filter housing
* Turn valve lever on the system head to "OFF"
or "BYPASS" position.
* Unscrew and remove the sump part from the
head part using the filter housing wrench.
* Remove black o-ring and inspect. Clean and
lubricate with silicone grease.
* Clean grooves in top of filter housing where the
o-ring sits.
* Place the clean, lubricated o-ring back in the
groove.
* Screw filter housing back onto the system head
and hand-tighten. DO NOT OVERTIGHTEN.
* Turn the valve lever on the system head to the
"ON" position and inspect for leaks.
Troubleshooting
Guide
* Turn o the main water supply.
* Purge water from plumbing lines by turning on
all faucets in your home and draining completely.
* Tighten all fittings.
* Turn on the main water supply, and turn the
valve lever on the system head to the "ON"
position and inspect for leaks.
* If leaks continue, disassemble the configured
system, reapply plumber's tape or sealant, and
reinstall the filter system.
Leaks around fittings
Note: Place paper towels or rag under the filter
system to catch any water drips.
WATER
OFF
BYPASS
FILTER
(WATER ON)