Operation Manual

23
SUBSTANCE REDUCTION
The above listed Water Filter Systems have been tested and certifi ed under NSF/ANSI 42 for reduc-
tion of chlorine, taste and odour. The performance of this product has been verifi ed and substanti-
ated as the test data summarised below indicates. These substances may not be in your water.
Test Data for Purity C 50 Quell ST
Substance
Guidelines
Average Infl uent
Concentration
Maximum Effl uent
Concentration
Minimum Percent
Removal
Average Effl uent
Concentration
Average Percent
Removal
Chlorine
NSF/ANSI 42 2.11 mg/l 0.40 mg/l 81.0 % 0.24 mg/l 88.7 %
*Test Data for Purity C 150 Quell ST
Substance
Guidelines
Average Infl uent
Concentration
Maximum Effl uent
Concentration
Minimum Percent
Removal
Average Effl uent
Concentration
Average Percent
Removal
Chlorine
NSF/ANSI 42 2.11 mg/l 0.40 mg/l 81.0 % 0.24 mg/l 88.7 %
*Test Data for Purity C 300 Quell ST
Substance
Guidelines
Average Infl uent
Concentration
Maximum Effl uent
Concentration
Minimum Percent
Removal
Average Effl uent
Concentration
Average Percent
Removal
Chlorine
NSF/ANSI 42 2.11 mg/l 0.40 mg/l 81.0 % 0.24 mg/l 88.7 %
Test Data for Purity C 500 Quell ST
Substance
Guidelines
Average Infl uent
Concentration
Maximum Effl uent
Concentration
Minimum Percent
Removal
Average Effl uent
Concentration
Average Percent
Removal
Chlorine
NSF/ANSI 42 2.03 mg/l 0.62 mg/l 69.0 % 0.40 mg/l 80.1 %
Test Data for Purity C 1000 AC
Substance
Guidelines
Average Infl uent
Concentration
Maximum Effl uent
Concentration
Minimum Percent
Removal
Average Effl uent
Concentration
Average Percent
Removal
Chlorine
NSF/ANSI 42 2.1 mg/L 0.05 mg/L 97.4 % 0.05 mg/L 97.6 %
*Values calculated on basis of the C50
Testing Conditions:
Flow Rate: 0.25 GPM pH: 7.5+/–0.5
Pressure: 60+/– 3 psgi Temperature: 20+/–3°C
Refer to your Instruction Guide for more specifi c product and warranty information and to avoid
contamination from improper handling and installation. Performance will vary based on local water
conditions. The substances reduced by this product are not necessarily in your water.
Buyer’s Signature Date Seller’s Signature Date
This appliance meets the domestic water treatment appliance Standards AS/NZS 3497 and
AS/NZS 4348 for the following water treatment process:
Class Treatment type Function Pass
I Microbiological Status
Bacteriostatic
Will stop bacteria increasing N/A
II Microbiological Treatment
Bacteria removal
Virus removal
Protozoa removal
Will remove or inactivate bacteria
Will remove or inactivate virus
Will remove or inactivate Crypto-sporidium and Giardia
N/A
N/A
N/A
III Turbidity and particulate reduction
Reduces cloudiness N/A
IV Taste and odour reduction
Reduces tastes and odours

V Chemical treatment
Decreases chlorine

LEGEND:
 = pass
N/A = Not Applicable