Operation Manual

10
4.2 Programming the Appliance
PROG RESET PROG RESET PROG RESET
“BATT” fl ashes when the
battery has run out
“PRG” fl ashes when the
programming mode is
activated
“1,2,3,4,5” fl ashes during
“Memory Call-Up” and
represents the memory
level that is being called up
4.2.1 Programming the Litre Information
Briefl y press the “PROG” button •
7
, the display changes to the programming mode,
“PRG” fl ashes in the display
8
. (How to identify the fi lter capacity is described in the
fi lter system manual.)
Note: Press the “PROG” button
7
again to leave programming without making any
changes.
Press the “RESET” button •
9
to jump to the litre information. The relevant number
fl ashes in the display
8
.
Press the “RESET” button •
9
until the desired number is shown fl ashing in the
display
8
.
Press the “PROG” button •
7
to reach the next digit to be entered. The relevant digit
fl ashes.
Repeat the steps above until the litre information determined has been entered.•
Press the “PROG” button •
7
to confi rm the litre information entered and to leave the
programming mode. The “PRG” fi eld in the display
8
no longer fl ashes.
The litre information entered is shown in the display •
8
, the system can now be com-
missioned.
4.3 Installation of the Sensor
Note: During installation, pay attention to the direction of fl ow.
Close the water inlet.•
If a fi lter system is already installed, remove the outlet hose •
4
by loosening the union
nut.
Tighten the union nut •
5
of the sensor
1
on the fi lter head. If necessary, insert a fl at
seal
6
.
Tighten the outlet hose •
4
on the sensor
2
.
!
Caution: The max. tightening torque at the 3/8" connections must not exceed
15 Nm!
4.4 Installation of the Display Unit
The display unit can be attached to the desired position with double-sided adhesive tape
or a screw (neither included in the delivery scope).
!
Caution: There must not be any water pipes or electrical
cables behind the mounting surface. Do not lay the connecting cable parallel to cables
conducting electricity because this can lead to an impairment of the sensor signal.