User guide

9
Installation Requirements
Flow Regulators
This shower valve is supplied with a 7 litre
per minute flow regulator fitted in each
water inlet which must be left in place
when installed in conjunction with an
instantaneous water heater/combination
boiler.
Fitting both flow regulators and turning
the water heater/combination boiler to its
hottest setting, will ensure a sufficiently
hot water supply to the shower valve
during winter months (in the UK), when
the mains cold water supply is at its
coldest.
In the event that this shower valve is not
installed with an instantaneous water
heater/combination boiler, the flow
regulators may be removed. Please follow
the steps detailed to remove the flow
regulators.
Using a thin flat bladed screwdriver
or similar tool, carefully prise the flow
regulators out of both inlets (1 & 2).
With the flow regulators removed from
the inlets, the plastic inserts (supplied)
must be fitted as shown, with the small
diameter first (3 & 4).
1
2
3
4