User guide

20
Installation - Riser Rail
1. Mark the position
Position the assembled riser rail on the
wall, bearing in mind the different heights
of people likely to use the shower and the
length of the hose when connected to the
shower.
With the riser rail vertical, mark the wall
bracket positions onto the wall.
Release the slider handle and remove the
slider and wall brackets from the rail.
2. Attach wall brackets
Position the bottom wall bracket onto
the marked position on the wall surface,
ensure it is vertical and mark the centres
of the fi xing holes onto the wall. Existing
fi xing holes maybe used as the bottom
wall bracket is fully adjustable.
Warning: Please check for any hidden
pipes and cables before drilling holes in
the wall.
Drill suitable holes and insert the wall
plugs. Securely attach the bottom wall
bracket to the wall using the screws
provided.
Tips: A piece of insulation or masking
tape positioned where holes are to
be drilled and before marking out the
exact position for the fi xing holes will
help stop the drill bit from wandering,
particularly on a tiled surface.
When working near a basin, bath or
shower insert plug or cover waste to
prevent losing small parts.
Take care not to drop tools/equipment
into basin, bath or shower during
shower installation.
Slider
handle
Wall bracket
Wall bracket
Wall bracket
Note: If replacing an existing riser rail,
check to see if the existing holes can
be reused or covered by the new wall
brackets. Try to avoid drilling close to the
edge of tiles, drill in the middle of the tiles
or in the tile joints.
For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - [e-mail]