Instruction Manual

© BriskHeat
®
Corporation. All rights reserved.
7
LYNX
TM
System Instructions
Connect the first Dock of each string to the Operator Interface Panel via
the communication connector on the power harness. Any of the available
input ports (1 - 8) may be used. Ensure all wiring connectors are fully and
properly engaged.
STEP 3: MOUNT OPERATOR INTERFACE STEP 4: CONNECT OPERATOR INTERFACE
Plug in the power connector on the back of the Operator Interface.
Once the Operator Interface is plugged in, it will immediately turn on. Once
it has fully booted up, configuration of the Operator Interface may begin.
Mounting Options:
VESA / FDMI Mount
75 x 75mm on center spacing.
M6 x 10mm Inserts Provided.
Keyhole Hangar
Quantity of 4 Keyhole hangars are provided.
For use with screws or anchors.
Recessed / Panel Mounted
Cut opening to the dimensions shown below.
Remove the four screws in the corners of the Operator Interface.
Insert the Operator Interface into the cutout.
Use the four extra screws provided to replace the four removed.
VESA Mount
Keyhole Hangar