Instruction Manual

LYNX

System Instructions

Connect Lynx Modules to docking stations, ensure clips are fully

engaged on both sides.

STEP 1: INSTALL HEATERS

Install the heaters onto the parts to be heated. Ensure that the heat-

ers make good contact across their entire area.

If not included in the heater, attach a temperature sensor to the part

as recommended by the heater manufacturer.

If using stand-alone Lynx docking station assembly, ensure heater

plug matches receptacle. Wire appropriate plug on heater if re-

quired.

STEP 2: ATTACH LYNX MODULES AND CABLES

Connect any additional Lynx docking stations to each other.

For stand-alone Lynx docking stations:

Connect RTD/Thermocouple sensors to the sensor port and

connect heater power plug to heater receptacle.

Ensure that all docking stations are secured properly to the heaters

or in such a way that the harness is not hanging freely. All modules

features a removable clip on the bottom that can be secured to a

variety of surfaces.

Connect a power harness to the first heater in each string and to

electrical power. All modules will start in Disabled Mode and will

therefore not heat until the control mode is changed by the operator.

LYNX SYSTEM SETUP GUIDE

STEP 1: INSTALL HEATERS