Instruction Manual

LYNX

System Instructions

1. Up Button

Used to move up through the Menu options and adjust param-

eters.

2. Down Button

Used to move down through the Menu options and adjust

parameters.

3. Function Button

Multi-use button used to access menu options, select and

enter new parameters, and save them. Refer to table 2 for

module programming instructions.

4. Display

Displays the current temperature, menu options, and parame-

ters.

5. Heater Output

Displays the current status of the heater output (on/off)

6. LED Indicator Light

Lighted display that provides the status of the LYNX Module.

Refer to table 1 for description of color codes.

1. Ethernet Port

Used to connect the Operator Interface Panel to an Internet

Connection or Local Area Network. (Required for Modbus

TCP/IP communication)

2. LYNX Module Communication Connector

Used to connect a LYNX Communication Harness to the Oper-

ator Interface Panel.

3. Dry-Contact Relay

Used to connect customer provided equipment to monitor

Alarms. Each Dry-Contact Relay corresponds with the com-

munication port above it.

4. Master Dry-Contact Relay

Used to connect customer provided equipment to monitor

Alarms in conjunction with a heating system, this relay is con-

nected to all 4-Pin connector ports.

5. USB Port

Used to connect a USB Storage Device* to the Operator Inter-

face Panel for uploading system drawings and exporting Data

acquired during operation with the panel.

* USB Devices must be formatted in FAT32 for proper communication

with the Operator Interface Panel.

LYNX HARDWARE OVERVIEW