Instruction Manual

LYNX

System Instructions

SYSTEM MENU

After Pressing the System Access button on the Operator Interface

Overview screen, the System Menu is brought up and contains the

following options:

1. Global Edit—See “Global Zone Edit” section

2. Operator Interface Settings—See “Operator Interface Settings”

section

3. Zone Presets—See “Zone Presets” section

4. Facility Setup—Allows you to redo the Operator Interface

Configuration setup as done in initial provision in the event the

layout of your installation changes.

5. Alarms—See “Alarms” section.

6. Network Settings—Access and edit network settings

7. Shutdown—Shuts down the Operator Interface

GLOBAL ZONE EDIT & MODULE FIRMWARE UPDATE

Behaves like the “Edit Parameters” screen for a Zone but will apply

the parameters to the entire system. Used if your whole system is to

be controlled to the same parameters.

Firmware Update Button—use this to update the module firmware if it

is out of date.

To update module firmware:

1. Insert a USB Flash drive into the side port of the Operator

Interface Panel. The Panel will prompt the user with a

confirmation that a USB Device has been connected. Select

“Eject” to disconnect the USB Flash drive or “Okay” to proceed

with the connection.

2. Select “Firmware Update” and select the firmware file to use in

the update. A progress bar on-screen will display the firmware

update progress. Modules will not operate or provide recordable

data while the firmware update is in progress.

Operator Interface Setting tabs:

• General—Access and edit System name, supply voltage

information, temperature units, date and time.

• Manage PIN—Edit and enable/disable the security lockout PIN.

• Factory Reset—This tab will allow you to reset the OI to its factory

defaults. This will delete all zone data and system settings.

• About—Version information for the Operator Interface and where

the software can be updated.

OPERATOR INTERFACE SETTINGS