Instruction Manual

SpeedTrace Self-Regulating
Heating Cable
© BriskHeat® Corporation. All rights reserved.
3
IMPORTANT SAFETY INSTRUCTIONS
•
Do not immerse heater in liquid.
•
Keep volatile or combustible material away from heater
when in use.
•
Use heater only in approved locations.
•
Keep sharp metal objects away from heater.
Failure to observe these warnings may result in electric
shock, risk of fire, and personal injury.
DANGER
!
End-User Must Comply to the Following:
•
Only qualified personnel are allowed to connect
electrical wiring.
•
Disconnect all supply power at the source before
making any power connections.
•
All electrical wiring must follow local electrical codes.
•
The person who performs the final installation / wiring
must be qualified for this work.
•
The end-user is responsible for providing a
suitable disconnecting device.
•
The end-user is responsible for providing a suitable
electrical protection device. It is highly recommended
that a ground fault circuit breaker is used.
Failure to observe these warnings may result in personal
injury or damage to the heater.
WARNING
!
Agency Approvals
A person who has not read and
understood all operating Instructions
is not qualified to operate this
product.
DANGER
!
•
Never handle the heating cable while it is in operation;
always disconnect the heating cable from the power
source and allow to cool prior to handling.
•
Inspect heating cable before use.
•
If spillage of foreign matter onto heater occurs,
disconnect from power source and clean after
heating cable has been allowed to cool.
•
Fasten heating cable to pipes using approved
methods only.
•
Do not repair damaged or faulty heating cable.
•
Do not crush or apply severe physical stress on
heating cable or cord assembly.
•
Unplug heating cable when not in use.
•
Do not use for other applications.
Failure to observe these warnings may result in personal
injury or damage to the heater.
CAUTION
!