Use and Care Manual

8
Set the Cold Temperature Setting
1. Press and hold the down arrow button for 3 seconds until the cold water button starts to blink and the current
cold water temperature appears on the display.
2. Use the up and down arrow buttons to scroll to your desired cold water temperature. The range is 39℉ to 59℉
(4˚C to 15˚C).
3. Press the lock button when nished. The temperature stops blinking and the time is displayed.
Set the Hot Temperature Setting
1. Press and hold the up arrow button for 3 seconds until the hot water button starts to blink and the current hot
water temperature appears on the display.
2. Use the up and down arrow buttons to scroll to your desired hot water temperature. The range is 174˚F to 194˚F
(79˚C to 90˚C).
3. Press the lock button when nished. The temperature stops blinking and the time is displayed.
Dispense Cold or Room Temperature Water
NOTE: Water will take approximately 1 hour after plugging in and turning on to become completely chilled.
1. Place a drinking glass or container under the tap and press the cold water button to dispense cold water or the
ambient water button to dispense room temperature water.
2. Release the button when your container is full.
Dispense Hot Water and Activate Child Safety Lock
CAUTION: This unit dispenses water at temperatures that can cause severe burns. Avoid direct contact with hot
water. Keep children and pets away from the unit while dispensing. Never allow children to dispense
hot water without proper and direct supervision. Disable the heating feature by switching the heating
convenience switch to the O position.
NOTE: Water will take approximately 15-20 minutes after plugging in and turning on to reach its hottest
temperature.
1. This water dispenser is equipped with a child safety feature in order to prevent inadvertent dispensing. To
disable the child safety lock feature, press the lock button.
2. To dispense hot water, place a drinking glass or container under the tap and press the hot water button.
3. Release the button when your container is full.
Change the Water Bottle
CAUTION: Do not dispense hot, cool or cold water if the change water bottle icon is flashing on the display as you
could empty the tanks and cause the dispenser to overheat.
When the bottle indicator icon on the top-right corner of the display begins to blink, it is time to replace your empty
water bottle with a new water bottle:
1. Open the dispenser cabinet door and slide the empty bottle out of the cabinet.
2. Remove the bottle adapter from the empty bottle and let the probe drip into the bottle. Once dripping has
stopped, place the bottle adapter on the hanger and set the empty bottle aside.
3. Follow the steps in Connect a Water Bottle to install your new water bottle.
4. Recycle the empty bottle at your local exchange center to receive your next bottle at a discount.