Use and Care Manual

E. Slide the water bottle into the dispenser

cabinet and close the door.

F. Wait 5 minutes for the water tanks to ll

with water before attempting to use the

dispenser.

G. Remove air from the tanks by placing

a cup under each water tap and drain

at least 4 cups (1 liter) of water before

initial use.

NOTE: Water will not pump from

the bottle until the door is

completely closed.

Operation

IMPORTANT: This unit has been tested and sanitized prior to packing and shipping. During transit, dust and

odors can accumulate in the tank and lines. Dispense and dispose at least one quart of water

prior to drinking any water.

Turn the Dispenser On/O

IMPORTANT: Before you turn the dispenser on and activate the hot and cold switches, ensure a bottle is

installed.

1. Plug in the dispenser and turn the On/Off switch to On.

2. Run water through the tap until water begins to dispense.

3. To power on the cooling system, ip the cooling switch on the back of the dispenser to the On position. The

cold water button on the front of the dispenser illuminates in blue indicating that the dispenser is cooling water.

The light turns off when the cooling process is complete.

4. To power on the heating system, ip the heating switch on the back of the dispenser to the On position. The hot

water button on the front of the dispenser illuminates in red indicating that the dispenser is heating water. The

light turns off when the heating process is complete.

Set the Clock

1. Press and hold the up and down arrow buttons for 3 seconds until the clock display begins to blink.

2. Press the cold water button to set the minute and the hot water button to set the hour. Use the up and down

arrow buttons to scroll until the correct minute/hour is displayed.

3. Press the hot water lock button when nished.