Use and Care Manual

Installation

1. Determine Installation Location

A. Place the dispenser upright.

B. Locate the dispenser on a hard and level surface in a cool shaded

location near a grounded wall outlet.

NOTICE: Do NOT plug in the power cord until the entire installation

section is completed.

C. Position the back of the dispenser no closer than 20 cm (8 in.) from a

wall and permit free airow between the wall and water dispenser.

2. Install the Drip Tray and Grid

A. Unwrap the drip tray (3) from the packaging material and slide it onto the

dispenser until it is secure in place.

3. Connect a Water Bottle

IMPORTANT: To prevent dry heating, do not turn on the heating and cooling switches until you complete the

steps in this procedure.

A. Remove the plastic wrapping and cap

from the water bottle and clean the new

bottle with a clean cloth.

B. Open the cabinet door and feed the

bottle adapter tube (7) into the water

bottle. Ensure the tube hits the bottom

of the bottle.

C. For a 5-gallon bottle, place the bottle

adapter (5) over the neck of the water

bottle and press securely into place.

D. For a 3-gallon bottle, press down on the

two tabs on top of the bottle adapter (5)

and slide the cap down the probe tubing

to adjust the bottle adapter to t.