User's Manual

MJ192 GB Issue 02

5.3 HIGH TEMPERATURE ALARM DISPLAY – If the measured temperature goes up by more than the figure in

the ALARM HI screen, the alarm will sound immediately and “+T” will be displayed. Press OK to silence the

alarm for 30 minutes.

If the high temperature problem rectifies itself the “+T” remains on the display to show this has happened. Press

OK to clear the indicator. Check the incubator is not (and has not been) in direct sunlight or too near a heat

source such as a room heater. It is advisable to candle eggs a number of times after this event to check for losses.

5.4 LOW TEMPERATURE ALARM DISPLAY – If the measured temperature goes down by more than the figure

in the ALARM LO screen, after 30 minutes “-T” will be displayed and the alarm will sound. Press OK to silence

the alarm for 30 minutes.

If the low temperature problem rectifies itself the “-T” remains on the display to show this has happened. Press

OK to clear the indicator. Check the incubator is not (and has not been) in a cold draught or that the room

temperature has dropped significantly. It is advisable to candle eggs a number of times after this event to check

for losses.

5.5 TURN SYSTEM PAUSE DISPLAY. (Please refer to section 9 for details)

TO PREVENT THE RISK OF POSSIBLE INJURY OR DAMAGE TO THE MECHANISM NEVER

INITIATE A TURN WITH THE DOOR OPEN.

DO NOT OPEN THE DOOR WHILE THE SHELVES ARE MOVING. AN ALARM SOUNDS AT THE

START OF EACH TURN TO WARN THE OPERATOR. THE SHELVES MAY BE STOPPED BY

PRESSING ANY BUTTON ONCE.

A turn may be initiated at any time by pressing buttons OK and - . The shelves may then be stopped in any

position (e.g. level to allow removal of the trays) by pressing any button. The turn is left in one of two states

depending on whether automatic turning is set on or off:-

If automatic turning is set to on (1) in the Main Menu the current turn is "paused". It may be restarted again by

pressing any button. If it is not restarted within 30 minutes an alarm sounds to remind the operator. This function

is useful for inspecting eggs.

If automatic turning is set to off (0) in the Main Menu then the current turn is cancelled. The shelves remain

fixed in their current position. This function is useful for using the incubator as a hatcher.

T 39.8C

H 45%+T/

T*32.1C

H 45%-T/

T*37.5C

PAUSE