User's Manual

MJ192 GB Issue 02
5
5 DIGITAL CONTROL SYSTEM
The Ova-Easy Advance control system utilises highly accurate, individually calibrated sensors for temperature and
humidity. Be cautious of low cost analogue or digital thermometers and hygrometers when comparing them with the
incubator display readings.
5.1 NORMAL OPERATION – Temperature and relative humidity are continuously displayed. Turning status
indicator shows if automatic turning is switched on or off.
The asterisk "*" adjacent to the temperature reading shows when the heater power is on. When warming the
asterisk will be continuously on, once warmed up the asterisk will slowly flash as the heater is pulsed to
maintain the correct temperature. When reducing the temperature setting the asterisk may go off, this is
normal.
The asterisk "*" adjacent to the relative humidity display is only on when the pump control output is on (see
section 8) and is only applicable when using the optional Brinsea Advance Humidity Management Module.
If automatic turning is switched off "=" is shown in the corner of the display.
If automatic turning is switched on a line "/" symbol is shown revolving in the corner of the display.
5.2 POWER LOSS DISPLAY – If power has been interrupted due to a power cut (or when first switching on) a “P”
is shown flashing on the bottom line of the display. Press OK for 2 or more seconds to clear the indicator. If the
reason for the power loss is not known check the power cable connections are secure.
Once the “P” indicator has been cleared, it is advisable to candle eggs a number of times to check for losses.
T*37.5C
H*45% /
T*37.5C
H 45% P/