User's Manual

MJ192 GB Issue 02
14
14 Servicing and Calibration
IMPORTANT: THE HEATER AND CONTROL SYSTEM ARE AT MAINS VOLTAGE. NEVER ATTEMPT ANY KIND
OR FORM OF SERVICING UNLESS THE MACHINE IS DISCONNECTED FROM THE MAINS ELECTRICITY
SUPPLY. RISK OF ELECTRIC SHOCK!
14.1 Under certain conditions it is possible that condensation may form on the inner walls. The presence of water
gathering at the base of the incubator does not affect the performance of your incubator and does not pose an
electrical hazard.
14.2 In case of failure first check that the mains power supply is working and that the mains cable connector is fully
engaged in the socket on the rear panel. The digital control system may be reset to the original factory defaults
by connecting the power supply while holding the OK button. Check temperature calibration after resetting to
defaults.
14.3 If the problem persists contact your distributor or Brinsea Products Service Dept.
14.4 The functional parts of the Ova-Easy Advance incubators are modular and parts are available and are readily
exchanged by a suitably qualified person equipped with basic tools. Fitting instructions are supplied with
replacement parts.
14.5 The digital temperature and humidity display is individually calibrated during manufacture but may be re-
calibrated if required. It is NOT RECOMMENDED
that this procedure is carried out by the user.
BE CAUTIOUS OF LOW COST ANALOGUE OR DIGITAL THERMOMETERS AND HYGROMETERS.
BRINSEA PRODUCTS LTD USES SOPHISTICATED EQUIPMENT TRACEABLE TO INTERNATIONAL
REFERENCE STANDARDS.
To access the Calibration Menu press all three buttons simultaneously to unlock the display.
PRESS ALL 3 BUTTONS TO UNLOCK THE CALIBRATION MENU
SELECT THE OPTION / RETURN TO THE MENU.
GO FORWARD ONE SCREEN / INCREASE THE VALUE.
GO BACK ONE SCREEN / DECREASE THE VALUE.