User's Manual

AE21 GB Issue 02
9
8.5 When most eggs have hatched (12 to 48 hours) remove the hatchlings to a brooder. The Brinsea EcoGlow
is ideal for poultry and waterfowl etc. The Brinsea TLC-40 or TLC-50 Brooder is recommended for
exotics.
8.6 During hatching the high humidity levels will fall dramatically when the lid is lifted and will take some
time to build up. Resist the temptation to open the incubator frequently – leave for at least 6 hours
between inspections.
9 Cleaning Up
IMPORTANT:
DISCONNECT THE INCUBATOR AND CRADLE FROM THE MAINS POWER SUPPLY DURING
CLEANING. RISK OF ELECTRIC SHOCK!
ENSURE THAT ALL ELECTRICAL PARTS ARE KEPT DRY. DO NOT IMMERSE THE YELLOW BASE.
9.1 NEVER WASH THE TRAYS, COVERS OR CABINET PARTS IN LIQUIDS OVER 50°C (120°F). DO
NOT USE A DISHWASHER TO CLEAN TRAYS, INCUBATOR BASE OR LID. Following each hatch
remove and wash the egg trays and dividers in Brinsea Incubation Disinfectant Solution. Wipe all other
internal surfaces with a soft cloth soaked in the solution. Do not immerse the hollow yellow base as fluid
may become trapped inside. Ensure that the instructions supplied with the fluid are followed.
9.2 Periodically unscrew the screws retaining the fan cover, remove the cover and soak. Dust and fluff may
be removed from the fan(s) and heater cord with a soft brush. USE NO LIQUIDS.
THE INCUBATOR MUST NOT BE USED WITHOUT THE FAN COVER FITTED. RISK OF
ELECTRIC SHOCK!
WARM AIR DISTRIBUTION WILL BE ADVERSELY AFFECTED IF THE FAN COVER IS NOT IN PLACE.
9.3 If a separate hatcher is used the procedure above should still be followed every two months.
9.4 The exterior of the incubator and Autoturn cradle may be cleaned with a damp cloth. Avoid allowing any
moisture to get inside mechanical housings.
9.5 Always clean the incubator before storage and ensure that the unit is totally dry inside and out. Run the
incubator with no water inside for 24 hours prior to storage to ensure it is completely dry.
10 Servicing
IMPORTANT: THE HEATER CORD AND CONNECTIONS ARE AT MAINS VOLTAGE. NEVER
OPERATE THE INCUBATOR WITH THE FAN COVER REMOVED. RISK OF ELECTRIC SHOCK!
10.1 In case of failure first check that the mains power supply is working and that the mains cable connector is
fully engaged in the socket beneath the cable cover. If the problem persists contact your distributor or
Brinsea Products Service Dept.
10.2 No lubrication or further servicing is required beyond the instructions above.