Full Product Manual

10 1019097-D

English Manual

NOTE: The Square Bearings must be completely inserted into the end panels.

 1) toward the center until there is no free play along the

shaft. Tighten the six nuts (A) securing these panels fully.

1. WEARING GLOVES:

Slide the 10 Tines (5)

and 20 Bearings (6) onto the

Tine Shaft (2) as illustrated.

NOTE: Round projections on Bearings (6) must

fit into holes in Tines (5) and into two holes of

opposite Bearing.

 

Bearing (17) into the



 

Washer (15) on the

Tine Shaft (2) and slide

the shaft through the

end panel.

Step 4-B

ASSEMBLY

CAUTION: GlOves Are reqUIred.

Tines have extremely sharp points. Use caution when working around them.