Use and Care Manual

7
ASSEMBLY
=========================================================================================
1018348-A
3. Attach pivot bracket (5) to the
mount plate (2) using:
- x 2 Carriage Bolts (23) – 1/4” x 1”
- x 2 Lock Nuts (39) – 1/4”
Assembly Step 2
39
23
39
23
5
2
7/16” Wrench
For the rst step, you’ll need
to remove hardware from the front
of your mower.
12mm Wrench
A
A
B
B
Assembly Step 1
Unscrew the two skid plate bolts (A)
and two sets of washers (B).
1. Loosely start to attach the mounting
plate (2) to your mower by reusing the
removed hardware (A & B) as well as
U-bolts found in the hardware bag:
- x 2 U-Bolts (22)
- x 4 Washers (33) – 1/4”
- x 4 Lock Nuts (39) – 1/4”
7/16” Wrench
2. Align the bottom of the mounting plate (2)
parallel to the ground and make sure the
front of the mounting plate is touching the
inside edge of the bumper tubing. Tighten
all hardware.
39
33
22
2
A
A
B
B
2
The bottom of the mounting
plate (2) needs to be parallel to the ground.